UniToken Integration Guide Windows 2003 Server Smart Card Configuration
Network configuration
Click on the start button, inside “Connect To”, open “Show all connections
Right-click on the icon of the connection between clients and the domain controller and select “Properties”
In the properties window of the connection, select Internet Protocol (TCP/IP) and click on the “properties” button just below.
In the Internet Protocol (TCP/IP) Properties window, select [Use the following IP address] and input the static IP address, subnet mask and default gateway for your server.
For DNS settings, select [Use the following DNS server addresses] and input the same IP address as your static IP address.(We will use this server as the main DNS server)
Active Directory Installation
In the start menu, choose “Run…”
Input “dcpromo” and click OK to launch the Active Directory wizard.
On the Active directory wizard welcome screen, click on [Next]
On the [Operating system compatibility] page, click on [next].
On the [Domain Controller Type] page, Verify that [Controller for a new domain] is selected and click [Next]
On the [Create New domain] page, verify that [Domain in a new forest] is selected and click on the button [Next]
On the [New Domain Name] page, input a name for your domain and click on [Next]
On the [NetBios domain name] page, accept the suggested NetBios name or input a new one. Then, click on [Next]
On the [Database and log folders] page, click on [Next]
On the [Shared System Volume] page, click on the button [Next]
On the [DNS Registration Diagnostics] page, select [Install and configure the DNS server on this computer, and set this computer to use this DNS server as its preferred DNS server] and click on [Next].
On the [Permissions] page, select [Permissions compatible only with Windows 2000 or Windows Server 2003] and click on [Next].
On the [Directory Service Restore Mode Administrator Password] page, set the password for the administrator of the restore mode and click on [Next].
On the [Summary] page, verify the settings that you have input until now and click on [Next].
Wait until the configuration of Active Directory ends. To complete the procedure, Windows Server 2003 CD-ROM is required.
This screen reports if Active Directory has been installed correctly or not. Check that there is no error and click [Finish] to close the wizard.
